- Remove Front Wheels. Remove Front Brake Calipers. Remove Front Brake Rotors. Clean Contact Surface of Hub. Set Front Rotors up on Brake Lathe and Machine. Measure to insure with in Specification. Machine Left and Right Side Brake Rotor. Replace Front Brake Pads and Lubricate Caliper Slides. Rotate and Balance Tires
- Remove Rear Wheels. Remove Rear Brake Calipers. Remove Rear Brake Rotors and Clean Contact Surface of Hub. Replace Rear Brake Rotors. Clean and Lubricate Rear Brake Caliper Slides. Apply BG Stop Squeal to Brake Pads. Install Rear Brake Pads and Sensors (if equipped). Road Test Car and Properly Seat Rear Brake Pads.
- Perform Brake Fluid Exchange. Drain Master Cylinder Reservoir. Remove All Four Wheels and Bleed Brakes at Each Caliper. Refill Master Cylinder Reservoir and Adjust Fluid Level as Required. Install all Four Wheels and Torque as Required.
Anthony B. gave our service a 5 star review on 3/7/2022